Thingiverse
Automotive
Model downloaden
E46 Vent Gauge Pod
48
Downloads
54
Likes
0
Makes
A 52mm gauge pod meant to fit into the driver side air vent. Fits into the factory vent fin mounting holes.
NOTE: Some people are having issues figuring out the size to print so I am adding this edit. The width from the front of the pod to the rear is 40mm. To reword this, the smallest axis should be 40mm, the middle would be around 60mm.
NOTE: Some people are having issues figuring out the size to print so I am adding this edit. The width from the front of the pod to the rear is 40mm. To reword this, the smallest axis should be 40mm, the middle would be around 60mm.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
