EAchine E129 Helicopter Canopy

Here is a replacement canopy for the EAchine E129 micro R/C helicopter. Although EAchine say the EAchine E129 is tough and hard to break Heli I found the canopy broke real easy having glued it back together I thought it would be good to make a tough replacement 3D printed using PETG.I decided not to include any cutaways so it would be easy to 3D print in Spiralize mode (Vase mode) and then by just using the scale command in Cura I could within reason reuse the design for bigger helicopters.I used the original canopy as a template to mark out the cutaways and then used small sharp scissors to remove them.

Do not drill the mounting holes as the cut edges may cause tearing instead us a sharp soldering iron tip or a hot wire to make suitable size holes.