MakerWorld
RC
Go to Model
Eachine H8 3D Frame
17
Downloads
9
Likes
4
Makes
SummaryThis is an alternative frame for the little Eachine H8.The problem I found in the original shell-looking frame was the flexibility of its arms, and how easily they could be bent, directly affecting on how it flew.My version is slightly heavier than the original, but I personally find the behaviour of the quad is smoother, more stable and more predictable now. However, the fact that my version of the frame is a tad heavier, means the quad has less total useable thrust, but for flying indoors I don't think a lot of punch is needed. That being said, it stil has enough power to flip.Print SettingsPrinter: Folger Tech Prusa i3 2020 Rafts: No Supports: No Resolution: 0.2 mm Infill: 100%Post-PrintingYou might have to enlarge the motor housing holes, depending on how your print turns out.
EAM5892 also publishes on
3 additional models across 1 more platforms
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!