Thingiverse
Eachine VR007 Portable Screen Conversion
von PyroPony
2
Downloads
8
Likes
0
Makes
This is two 3D printed parts to transform the Eachine VR007 to a complete portable FPV screen.
The needed parts :
- the main body + the cover [3D printed]
- a small switch to turn on or off the screen (5mm * 12mm)
- all components of the Eachine VR007
- some wires
- hot glue gun to secure the electronic parts
For the 3 buttons, I just designed a large hole where you can fit the control panel after removing the button cap. if you want you could easily design your own 3D printed cover for this part.
At the end you should just have to snap fit the cover.
The needed parts :
- the main body + the cover [3D printed]
- a small switch to turn on or off the screen (5mm * 12mm)
- all components of the Eachine VR007
- some wires
- hot glue gun to secure the electronic parts
For the 3 buttons, I just designed a large hole where you can fit the control panel after removing the button cap. if you want you could easily design your own 3D printed cover for this part.
At the end you should just have to snap fit the cover.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!