Thingiverse
Earring Got7 pendant keychain
door instintkiller_
1
Downloads
3
Likes
0
Makes
The speed will depend on the machine and the type of PLA you are using. I always recommend that the first layers be printed at a speed between 10% and 20% (although if you are confident and know that the bed is perfectly leveled, you can increase the speed of the first layer to 40%). After that, you can adjust the speed as needed, keeping it between 80% and 100%.
The 3D model of these rings does not require supports, but I always advise keeping them active in case of any minor detail that the ring may need (that varies depending on the program you are using or your machine).
Remember to add supports to ensure a proper attachment.🧀🧀
I'm a bit sleepy, can you help me with a beer? It's to keep creating things 👽🤘 buymeacoffee.com/instintkiller
or follow in instagram @instintkiller_ / @depulga
tiktok @flea3d
Can you help me with a like or a follow?
The 3D model of these rings does not require supports, but I always advise keeping them active in case of any minor detail that the ring may need (that varies depending on the program you are using or your machine).
Remember to add supports to ensure a proper attachment.🧀🧀
I'm a bit sleepy, can you help me with a beer? It's to keep creating things 👽🤘 buymeacoffee.com/instintkiller
or follow in instagram @instintkiller_ / @depulga
tiktok @flea3d
Can you help me with a like or a follow?
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
