Thingiverse
Earring Holder
von ldouglas64
32
Downloads
24
Likes
0
Makes
My wife needed a way to store her earring collection so I designed this rack.
Each layer will hold 18 pairs of earrings with a tray to hold small items like earring backers, rings, etc. The upright rod is 1/4 inch dowel rod bought at the local hardware store. It would probably work better with 1/4 steel rod. The lock rings use a M3x8 hex screw to lock the ring to the upright rod at the desired height.
Next Version will probably have a thicker rod.
Printed on my Ender 5 Plus.
Each layer will hold 18 pairs of earrings with a tray to hold small items like earring backers, rings, etc. The upright rod is 1/4 inch dowel rod bought at the local hardware store. It would probably work better with 1/4 steel rod. The lock rings use a M3x8 hex screw to lock the ring to the upright rod at the desired height.
Next Version will probably have a thicker rod.
Printed on my Ender 5 Plus.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!