Easter bunny Hueforge

Model is 120x200 mm in size. You can only modify the X and Y dimensions. Do not adjust the height (Z) in your slicer! The layers would not be correct. You may print at higher layer heights below the Min Depth of 0.48mm. The Max Depth is 1.9mm and the Actual Depth is 1.9mm It is possible to print without AMS by manually changing the filament (setting filament change or pause) in the slicer, depending on your printer and sw support. These were my settings and colors for my print that you see in the picture. Your results may be depending on the filament you use. Filaments Used: PLA PolyLite Black Transmission Distance: 0.3 PLA Sunlu META Grey Transmission Distance: 3.6 PLA BambuLab Basic Orange Transmission Distance: 4.8 PLA Eleg.oo + White Transmission Distance: 6 This print uses 4 unique filaments Swap Instructions: Start with Black At layer #8 (0.72mm) swap to Grey At layer #11 (0.96mm) swap to Orange At layer #13 (1.12mm) swap to White for the rest.