Happy Easter Decor

Printer Setting Instructions Set Up the SlicerSlicing Software: Use software like Cura, PrusaSlicer, or Simplify3D.Layer Height: Lower values (e.g., 0.1 mm) for fine details; higher values (e.g., 0.3 mm) for faster prints.Infill Density: Adjust based on strength requirements (10-20% for most projects, higher for strength). Prepare the PrinterLevel the Bed: Ensure the print bed is level for proper adhesion.Clean the Bed: Use isopropyl alcohol to remove dust or grease.Check Filament: Ensure the filament is properly loaded and free from tangles. Monitor the PrintFirst Layer: Watch the first layer to ensure proper adhesion and no warping.Temperature: Maintain the correct nozzle and bed temperature for the material.Watch for Issues: Pause if you notice under-extrusion, stringing, or layer shifting. Post-ProcessingSanding: Sand the print for a smoother finish.Painting: Apply primer before painting for better adhesion.Resin Prints: Wash with isopropyl alcohol and cure under UV light.K1 Printer, approx. 25 min print time FOR BOTH PRINT , 0.2mm layer height, 10% infill, PLA material., print in place.