Easter Egg Bunny

Just in time for Easter! This cute egg dressed as a bunny is sure to make someone say “awwwwww”! A quick print that doesn't require supports or ams and is fun to assemble! For a good rainbow effect on these, print them 2 or more at a time to get the most colorful models! These are just shy of 6 inches tall to the tip of the ears. To assembleSlide the pupils into the white part of the eyes for both sides. Just be sure to match up the angles and curves side to side.Next insert the eyes into the model as shown along with the nose again paying attention to the orientation of each piece.The last step is to place the foot and ear inserts in. The oval parts are side specific. On the ears, there is a bigger space from the tab to the lower part than the top, Be sure to check alignment before pushing in fully for both the feet and the ears. The toe inserts are the same for all six and orientation doesn't matter. Have fun and experiment wit colors! please post your makes so we can see all