MakerWorld
Architecture
Zum Modell
Easter Egg Straw Topper - Geometric Egg
21
Downloads
27
Likes
10
Makes
Here is a fun Egg Shaped Straw Topper to be used with Stanley Straws or any straw similar in size. I remixed an open source geometric egg to be hollow with enough support to be sturdy. If you like the print, I'd love the support of “liking” the model, and check out my other stuff! I'm learning some modeling softwares and will be adding new models weekly. This won't fit a straw that is larger than a “normal” Stanley Straw but you could scale it up to fit slightly larger straws. Notes: The example photos are used with the exact print profile listed. You could probably increase layers to 0.2mm and play around with the infill to maximize print speed but the default profile listed will give you a nice finished product. IMPORTANT: DO NOT REMOVE BRIM, due to the size, I added a 10mm outer brim to secure the print. If you remove this you may have adhesion issues due to the base of the egg being so small.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!