Easter Eggs (pink)

Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm. Models have size 57x80 mm. You can scale it only to modify the X and Y dimensions. Do not adjust the height (Z) in your slicer! The layers would not be correct. You may print at higher layer heights below the Min Depth of 0.72mm. The Max Depth is 1.8mm and the Actual Depth is 1.8mm   In the profile are two beds. Models are identical, but the second bed is include a negative part cylinder = make a hole for hanging. Is possible to print without material system by manually changing the filament (setting filament change or pause) in the slicer, depending on your printer and sw support.   These were my settings and colors for my print that you see in the picture. Your results may be depending on the filament you use. Filaments Used:   PLA Aurapol Nude Transmission Distance: 3.2     PLA Elegoo + White Transmission Distance: 6 This print uses 2 unique filaments   Swap Instructions:     Start with Dark Red     At layer #11 (0.96mm) swap to White for the rest.