Easter Silhouette Panels

Easter set of panels for my Ring Lamp    This panels works with Ring Lamp II https://www.makeronline.com/en/model/Ring%20Lamp%20with%20Halloween%20Panels/47185.html For convenience I uploaded parts of this lamp in print profile “Ring Lamps Parts”   For now there are available panels for Halloween, Christmas, Valentine's Day and Easter.   Instruction I copied this instruction from Ring Lamp II.   Electric parts you need. The easiest way is to use electrical parts designed specific for this kind of lamp. The kit provides easy installation without the need for soldering. It is available on Amazon (Dimmer version) https://amzn.to/4iJ3zHt (On-Off switch version) https://amzn.to/3ZNb0q4   You can also search for each part separately. You will need led stripe - best are LED COB 8 mm, 12V charger for LED strip dc connector - I used 2.1/5,5 mm , the diameter of the mounting hole is 12 mm On-Off switch alternatively you can use dimmer instead of typical on-off switch WARNINGS Led strips can emits some heat depends on what type of LED and voltage you use. If you use LED strip from the kit you you can print everything in PLA as it achieve only about 40 °C. If you will use your own LED strip with more power it may achieve more temperatures (in my case 58 °C and Main Frame can a little bend overtime. If you have such strong LED strip I recommend use ASA instead of PLA. Specifically you have to print out with ASA the Main Frame and Panels. Everything else can be printed with PLA. Printing Printed with PLA or ASA, nozzle 0,4 mm, layer 0,28 mm height IMPORTANT Part: Shade55 - use 0,16 mm layer height as it has quite steep (55 degree) and thin( 0,6mm) walls If you have problem with that part then print “Shade45” Instruction (some photos from Crystal Lamp) Glue led strip to inner side of Main Frame Insert the electric part into the base and connect them. There is two type of base. One is holes place for dimmer and AC/DC connector. Second is with holes for on-off switch and AC/DC conne