Easy adjustment slider

This allows easy and accurate adjustment of the bullet flipper slide plate. Turning the screw provides fine control over the slider position to make tuning easy.

The "Mod Slider" and "Mod Bullet nose up module" replace the original parts.

Installation:
Step 1: Instal and screw down the "Mod Bullet nose up module" into the "Body"
Step 2: Inset the "Mod slider" into the "Mod Bullet nose up module".
Step 3: Screw the "Mod Adj Screw" into the "Mod Slider" until the smooth, small diameter section on the shaft aligns with the shaft holder part of the "Mod Bullet nose up module".
Step 4: Screw down "Mod screw cover" to "Mod Bullet nose up module" using two M3 x 8mm countersunk screws to capture the "Mod Adj Screw"