Easy Cable Management (Cable Label)

This 3D model is a super simple cable label solution that can be printed in under 2 minutes and uses less than 0.5g of material. The 5mm variant fits cables up to approximately 7mm in diameter, while a 7.5mm variant is included in the Fusion project (and will be uploaded later).

After testing various prototypes, I'm quite satisfied with the result. However, I want to credit "robomike," as his design is quite similar. I didn’t copy it, but the models share many similarities.


Print Settings:
Layer heigt: 0.2 mm
Line width: 0.4
Wall generator: Arachne (for better Quality on the Letters)
Wall loops: 3
Top/bottom shells: 1 Top / 4 Bottom (for Multicolor)
Infill: no need

Works great with PETG & TPU. PLA should also work fine.