Slicer Discord
Easy Print skeleton canopy for Tiny Whoop – 3D-Druckmodell von Thingiverse Thingiverse
Easy Print skeleton canopy for Tiny Whoop – Bild 1 Easy Print skeleton canopy for Tiny Whoop – Bild 2 Easy Print skeleton canopy for Tiny Whoop – Bild 3 Easy Print skeleton canopy for Tiny Whoop – Bild 4 Easy Print skeleton canopy for Tiny Whoop – Bild 5 Easy Print skeleton canopy for Tiny Whoop – Bild 6

Easy Print skeleton canopy for Tiny Whoop

von DiAleksi
304 Downloads
248 Likes
3 Makes
Zum Modell
Quick design of skeleton canopy for Tiny Whoop. Based on BetaFPV's Beta65 quad.

Easy print design to print without supports.

**Update 7.3.2018**
There's two version of this skeleton canopy.
Fat - the normal one for most cameras. Use this :)
Slim - for very tiny cameras.

**Update 8.3.2018**
Added Fat v2 version. There is an opening on the bottom of the camera hole for easier access to the screw.
Quelle
Thingiverse
Was du zum Drucken brauchst: Anfänger Niedrige Konfidenz
Warum?
keine Supports
Ohne Supports Einteilig Hardware nötig
Supports 0/3
Zusammenbau 0/3
Einstellungen 1/3
Druckbett 0/3
Nachbearbeitung 1/3
Drucker
FDM / FFF
Dateiformat
STL
Material
Nachbearbeitung
Hardware
Software
Cura, PrusaSlicer o. Ä.
Gleicher Designer, mehr Plattformen

DiAleksi veröffentlicht auch auf

26 zusätzliche Modelle auf 2 weiteren Plattformen

Verifiziert durch übereinstimmende Modelltitel über Plattformen hinweg.
Noch keine Bewertungen
Noch keine Kommentare – sei der Erste!
Feed Blog Slicer Kostenrechner Bildersuche Einreichen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Zur Sammlung hinzufügen