Easy-Swap Thread Spool Holder

A thread spool holder with an easily detachable magnetic side for 35-65mm long spools that also includes an embroidery scissors holder and space for a donut-shaped pin cushion or scrunchy.

Materials:
• PLA/PETG
• 4x M4 20mm screws
• 2-4x M4 nuts
• 4x 10x3mm Cylindrical magnets
• Super glue (for the magnets)
• Donut Pin Cushion (see instructions below) OR Scrunchy (see instructions below)
• Spare pennies (optional) (for adding weight)
• Wall tack (optional) (or any small non-slip feet alternative)

Printing Notes:
• Print at 0.2mm layer height
• No supports are required to print this device, although I recommend using a few for the overhangs created by the M4 nut indents.
• Consider printing the parts with more perimeters and higher infill to increase the device's overall weight.

Other Notes:
• The thread spool holder positioner works in increments of 35, 45, 55, and 65mm

Donut Pin Cushion Instructions:
1. Cut two circles with a 6-inch diameter out of a fabric of your choice (recomme