Thingiverse
Ebikeling S830 display stem mount
por bugeye59
8
Descargas
3
Likes
0
Makes
If you enjoy my 3d models then please consider buying me a cupof coffee at my Paypal tip page:
https://www.paypal.com/donate/?hosted_button_id=ZRLFSSPLF5S4Y
Your support will be appreciated and will allow me to continue delivering new and interesting 3d models.
Be sure to check out all my other designs at: https://www.thingiverse.com/bugeye59/designs
By default the Ebikeling S830 display can only mount to the handlebars. This was not going to work for me so I made up this mount to put it on the handlebar stem which is 38mm in diameter.
You will want to use a strong plastic when you print this. I printed this with Priline PC carbon fiber, but you could probably get by with PETG.
Print at 100% infill with supports.
https://www.paypal.com/donate/?hosted_button_id=ZRLFSSPLF5S4Y
Your support will be appreciated and will allow me to continue delivering new and interesting 3d models.
Be sure to check out all my other designs at: https://www.thingiverse.com/bugeye59/designs
By default the Ebikeling S830 display can only mount to the handlebars. This was not going to work for me so I made up this mount to put it on the handlebar stem which is 38mm in diameter.
You will want to use a strong plastic when you print this. I printed this with Priline PC carbon fiber, but you could probably get by with PETG.
Print at 100% infill with supports.
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
