Thingiverse
EC-17 Blaster Stand
by Whifflesauce
32
Downloads
18
Likes
0
Makes
Couldn't find a blaster stand design for an EC-17 Blaster, so I made one.
Hello pathfinders, here is a simple stand to display your prestigious hold-out blaster. Keep it ready, keep it safe, and keep those Rebel scum at bay!
This was designed to hold the blaster I have, some blasters are made smaller than others. For sizing the front post is 52 mm tall and the rear stabilizers are 65 mm behind the post.
Info plate is a separate file, change filament to make text pop!
There is an off centered hole in post to accommodate a screw holding my trigger guard in place. The posts on the plate may need some clean-up/adjusting to sit in the holes, but it should lean back at a slight angle.
The blaster pictured and used for designing this stand was purchased from Darth Voorhees on the 501st pathfinder forum.
Hello pathfinders, here is a simple stand to display your prestigious hold-out blaster. Keep it ready, keep it safe, and keep those Rebel scum at bay!
This was designed to hold the blaster I have, some blasters are made smaller than others. For sizing the front post is 52 mm tall and the rear stabilizers are 65 mm behind the post.
Info plate is a separate file, change filament to make text pop!
There is an off centered hole in post to accommodate a screw holding my trigger guard in place. The posts on the plate may need some clean-up/adjusting to sit in the holes, but it should lean back at a slight angle.
The blaster pictured and used for designing this stand was purchased from Darth Voorhees on the 501st pathfinder forum.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
