Slicer Discord
echo_show_5_-_base_ceramic_magnets – 3D-Druckmodell von Thingiverse Thingiverse

echo_show_5_-_base_ceramic_magnets

4 Downloads
3 Likes
0 Makes
Zum Modell
Remixed for magnets already available.
Round 18mm Ceramic Magnets that measured 17.5mm x 5mm.
Anpro Ceramic Magnets 0.69 Inch (18mm) Round Magnet Disc Amazon B072HV6NLB

Holes are extra deep to allow for blob of epoxy in bottom and then magnet pushed down to be level with surface using flat non-ferrous object i.e. plastic container.

In slicer, painted supports in a strip down the slot for the Mount and around the hole for the Pin.


Thanks to @waschbaerbauch75 for the original design!
https://www.thingiverse.com/thing:4182196
Quelle
Thingiverse
Was du zum Drucken brauchst: Mittel Niedrige Konfidenz
Warum?
aufwändige Nachbearbeitung
Einteilig Hardware nötig
Supports 1/3
Zusammenbau 0/3
Einstellungen 1/3
Druckbett 0/3
Nachbearbeitung 2/3
Drucker
FDM / FFF
Dateiformat
STL
Material
PLA
Nachbearbeitung
Kleben, Hardware
Software
Cura, PrusaSlicer o. Ä.
Gleicher Designer, mehr Plattformen

CPS_Systems veröffentlicht auch auf

347 zusätzliche Modelle auf 2 weiteren Plattformen

Verifiziert durch übereinstimmende Modelltitel über Plattformen hinweg.
Noch keine Bewertungen
Noch keine Kommentare – sei der Erste!

Ähnliche Modelle

6 Vorschläge
Feed Blog Slicer Kostenrechner Bildersuche Einreichen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Zur Sammlung hinzufügen