Thingiverse
Echo Show 8 Stand (10x10cm small printer)
by mr_zoreta
50
Downloads
45
Likes
0
Makes
This is a remix of an echo show 8 support that I found - https://www.thingiverse.com/thing:4049560
I made corrections to the mesh and resized the support to fit 10x10cm printers (Like mine)
I used 12x2mm magnets to hold the echo show 8, and fixed them to the holder with super glue.
My magnets were not super strong, and I also decided to put a strip of double-sided tape (Drand 3m) to help fix it.
(I also used screws and nuts different from the one I printed, expanding the hole was easier than going out to buy screw eggs)
My printer had some errors in printing, but the end result became extremely functional!
If that helps you, consider making a donation - https://bit.ly/3gBdWfU
I made corrections to the mesh and resized the support to fit 10x10cm printers (Like mine)
I used 12x2mm magnets to hold the echo show 8, and fixed them to the holder with super glue.
My magnets were not super strong, and I also decided to put a strip of double-sided tape (Drand 3m) to help fix it.
(I also used screws and nuts different from the one I printed, expanding the hole was easier than going out to buy screw eggs)
My printer had some errors in printing, but the end result became extremely functional!
If that helps you, consider making a donation - https://bit.ly/3gBdWfU
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!