Thingiverse
Eclipson Model V plane hanger
door Iron-Hide
5
Downloads
6
Likes
0
Makes
Super simple design to hang my Eclipson Model V from my garage roof beams.
I have a plane and quadcoptor problem and the problem is I have too many of them :)
My solution is to hang my planes vertically. Works for me, ' Rack 'em and Stack em ' if you will.
Tie the rope used for the hanger together in the middle in the tail area. If you do this then the rope does not touch the tail sections so no long term distortion can happen.
The hanger follows the wing profile with a 2 - 3mm gap from the wing. This gap is to enable you to put some self adhesive dense foam between the wing and the hanger as seen in the pictures
I have a plane and quadcoptor problem and the problem is I have too many of them :)
My solution is to hang my planes vertically. Works for me, ' Rack 'em and Stack em ' if you will.
Tie the rope used for the hanger together in the middle in the tail area. If you do this then the rope does not touch the tail sections so no long term distortion can happen.
The hanger follows the wing profile with a 2 - 3mm gap from the wing. This gap is to enable you to put some self adhesive dense foam between the wing and the hanger as seen in the pictures
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!