Ecto 1 Radome
von Dax79
51
Downloads
30
Likes
0
Makes
Full size 1:1 Radome for Ghostbusters Ecto 1 Ectomobile roof rack.
It's about a 1cm too short as I needed it to fit on my print bed.
I would recommend printing in ABS or other plastic that will last out in the sun. PLA seems to get soft in the hot summer sun.
This does not have the two red lines through it. I have decided to paint it up after.
I hope this helps other GhostHeads out there! I will be posting my Ecto on my YouTube channel soon so feel free to pop past to check it out!
I will add more photos soon (Radome is printing now :) )
www.youtube.com/dax79
It's about a 1cm too short as I needed it to fit on my print bed.
I would recommend printing in ABS or other plastic that will last out in the sun. PLA seems to get soft in the hot summer sun.
This does not have the two red lines through it. I have decided to paint it up after.
I hope this helps other GhostHeads out there! I will be posting my Ecto on my YouTube channel soon so feel free to pop past to check it out!
I will add more photos soon (Radome is printing now :) )
www.youtube.com/dax79
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
