Slicer Discord
EDC Craft Knife – 3D-Druckmodell von MakerWorld MakerWorld
Gadgets

EDC Craft Knife

4 Downloads
1 Likes
0 Makes
Zum Modell
This is an EDC craft knife that I designed when I could not find what I was looking for on MakerWorld. I'm uploading two different designs, one which uses an M2 3.2X4mm heat insert to clamp the blade into place, and the other uses an M2 nut. Both designs utilize a small spring that creates a semi-locked position on both the top and bottom of the slider’s position inside the main body while the bolt that holds the blade into place also pulls double duty by clamping the blade into place and also acting as a captive lock keeping the slider assembly from falling out. Dimensions10mm x 16mm x 100mm, assembled masses are 11.7 grams for the heat insert and 11.9 grams for the nut insert. Heat Insert Required Tools1X Heat Set Inserter1X 1.5 hex driver BOM1 X 3D print (Main Body, slider, “spring”)1 X M2 heat insert1 X M2 hex socket 4mm1 X #11 craft knife (X-acto and generic should both work) Assembly Instructions Step 1A. Insert the insertThis design calls for a M2 3.2 X 4mm heat insert, but
Kategorie
Gadgets
Quelle
MakerWorld
Veröffentlicht
Aktualisiert
Was du zum Drucken brauchst: Mittel Niedrige Konfidenz
Einteilig Hardware nötig
Supports 1/3
Zusammenbau 0/3
Einstellungen 1/3
Druckbett 0/3
Nachbearbeitung 1/3
Drucker
FDM / FFF
Dateiformat
STL
Material
PLA
Nachbearbeitung
Hardware
Software
Cura, PrusaSlicer o. Ä.
Noch keine Bewertungen
Noch keine Kommentare – sei der Erste!

Ähnliche Modelle

6 Vorschläge
Feed Blog Slicer Kostenrechner Bildersuche Einreichen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Zur Sammlung hinzufügen