Thingiverse
EDF RC Boat
von JSeds
181
Downloads
165
Likes
4
Makes
This is an EDF boat I designed after seeing RCLifeOn's video of his custom EDF RC boat. This prints in two parts and requires a print height of at least 240mm and a length/width of 190mm or so.
There are two models, Mk. 1 and Mk. 2:
I have printed Mk. 1 which is a joy to drive but a little on the small side for a pond with any waves as you can see in the video.
Mk. 2 was designed to be able to handle waves better and is better suited for the 64mm edf. I have not printed this version yet, but it should work flawlessly as Mk. 1 did. The main difference is that Mk. 1 is meant to drive on land as Mk. 2 isn't, but still could.
The servo sits in the back and attaches directly to the rudder. The top of the rudder is secured to the EDF. Make sure you use a 9 Gram servo that is waterproof as the servo is submerged during normal operation.
The bow and stern can be glued together with epoxy. The type I recommend is classic jb weld, steel-reinforced epoxy. Most of the screw holes ar
There are two models, Mk. 1 and Mk. 2:
I have printed Mk. 1 which is a joy to drive but a little on the small side for a pond with any waves as you can see in the video.
Mk. 2 was designed to be able to handle waves better and is better suited for the 64mm edf. I have not printed this version yet, but it should work flawlessly as Mk. 1 did. The main difference is that Mk. 1 is meant to drive on land as Mk. 2 isn't, but still could.
The servo sits in the back and attaches directly to the rudder. The top of the rudder is secured to the EDF. Make sure you use a 9 Gram servo that is waterproof as the servo is submerged during normal operation.
The bow and stern can be glued together with epoxy. The type I recommend is classic jb weld, steel-reinforced epoxy. Most of the screw holes ar
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
