Edge Clamp

Edge clamp that attaches to f-clamp to hold veneer in place on the edge of ply while glue dries. I didn't want to spent a lot on new edge clamps when I will only use them occasionally.

Uses M8 threaded rod or M8 bolt and 2 x m8 nuts. There is a swivel pad at the end to hold veneer flat.

Also tried the clamp pad from here as they are shorter and better for shorter arm clamps:
https://www.thingiverse.com/thing:32481

The threaded rod is cut at 90mm so it has extra length to fit several size clamps, but can be changed to suit.

I have printed with 60% infill so is stronger, this is only intended to hold parts in place while glue dries, not to crank up as tight as possible.

The knob I already had printed for another project but fits nicely here.