Electronics
Zum Modell
Edge Header Programmer Clip Via Probes (e.g. OpenLog Clone) (Customisable)
47
Downloads
63
Likes
0
Makes
Edge Header Programmer Clip Via Probes (e.g. OpenLog Clone)
Author: Brian Khuu 2019
This is originally designed for connecting to OpenLog Clones
I used P100-E2 probes for this
Note: The purple openlog clone Programmer Port essentally has [GND, RST, SCK, M0, MI, Vin]
-----------------------------
FYI if programming openlog connect above to
AVR ISP
```
[MISO(1)][VTG(2)]
[SCK(3)][MOSI(4)]
[/RES(5)][GND(6)]
```
```
[MOSI(1)][VTG(2)]
[NC(3)][GND(4)]
[/RES(5)][GND(6)]
[SCK(7)][GND(8)]
[MISO(9)][GND(10)]
```
-----------------------------
Note: I've also included an experiment, where I included a side grip version. Haven't tested it in practice besides a few test prints, but you can let me know if it works. The nice thing about the experimental version, is it should be easier to use and also adapt to other board types
Author: Brian Khuu 2019
This is originally designed for connecting to OpenLog Clones
I used P100-E2 probes for this
Note: The purple openlog clone Programmer Port essentally has [GND, RST, SCK, M0, MI, Vin]
-----------------------------
FYI if programming openlog connect above to
AVR ISP
```
[MISO(1)][VTG(2)]
[SCK(3)][MOSI(4)]
[/RES(5)][GND(6)]
```
```
[MOSI(1)][VTG(2)]
[NC(3)][GND(4)]
[/RES(5)][GND(6)]
[SCK(7)][GND(8)]
[MISO(9)][GND(10)]
```
-----------------------------
Note: I've also included an experiment, where I included a side grip version. Haven't tested it in practice besides a few test prints, but you can let me know if it works. The nice thing about the experimental version, is it should be easier to use and also adapt to other board types
mofosyne veröffentlicht auch auf
63 zusätzliche Modelle auf 1 weiteren Plattformen
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!