Thingiverse
EdgeSwitch 10x stand
door kevincork
12
Downloads
7
Likes
0
Makes
This is a stand for the Ubiquiti EdgeRouter 10x.
I didn't removed all the support as you can see on the pictures as I don't use all, and there is no holes for SPF, but I added the blender file so you guys can customise as you want.
is not a great design but its ok enough for me, just need to be extra careful when removing the support as the "port" hole are very close to gather.
ethernet are going through the "port" hole from the back then a gain in the front.
I didn't removed all the support as you can see on the pictures as I don't use all, and there is no holes for SPF, but I added the blender file so you guys can customise as you want.
is not a great design but its ok enough for me, just need to be extra careful when removing the support as the "port" hole are very close to gather.
ethernet are going through the "port" hole from the back then a gain in the front.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
