Edifier MR4 Speaker Wall Mount

建议使用碳纤材料打印，PETG材料长时间可能会变形。PLA没有测试过。打印后用抛光液粘上链接件即可上墙。也可以简单在Bambu Studio中加上需要的挂钩适配洞洞板。也可以直接膨胀螺栓上墙。Suggested material: PETG-CF for printing. PETG may deform over time. PLA has not been tested. After printing, apply polishing fluid/adhesive to attach the linking parts before wall mounting. Alternatively, simply add hook adapters for pegboard in Bambu Studio. Or mount directly to the wall using expansion bolts/wall anchors.左右支架分别向中间和下方倾斜一定的角度，建议安装高度为桌面以上50cm，也可以酌情调节。为保证稳定，避免倾倒，可在音箱底部使用泡棉双面胶，兼顾减震效果。The left and right brackets should tilt slightly inward and downward. The recommended installation height is 50cm above the desktop, though this can be adjusted as needed. To ensure stability and prevent tipping, apply double-sided foam tape to the bottom of the speakers—this also provides vibration damping.