MakerWorld
Hueforge & Lithophane
Ver Modelo
Eevee Evolution Flareon Hueforge
41
Descargas
50
Likes
25
Makes
Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mmThe Model is 200x200mm in sizeYou may print at higher layer heights below the Min Depth of 1.4mmThe Max Depth is 3.3mm and the Actual Depth is 3.4mmFilaments Used:PLA BambuLab Black Transmission Distance: 0.3PLA BambuLab Basic Red Transmission Distance: 4PLA BambuLab Matte Mandarin Orange Transmission Distance: 3PLA BambuLab Basic Yellow Transmission Distance: 6This print uses 4 unique filamentsSwap Instructions:Start with BlackAt layer #20 (1.68mm) swap to RedAt layer #30 (2.48mm) swap to Mandarin OrangeAt layer #34 (2.8mm) swap to YellowBorder Only Colors from here until the end.At layer #39 (3.2mm) swap to Red for the rest. This Hueforge is meant to be a bit thicker than the average Hueforge prints. Artist: Sarah Richford - eeveelutions Flareon
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
