Thingiverse
Effector Fan Shroud
von SummersideGuy
47
Downloads
14
Likes
0
Makes
I did not like the restricted air flow on the heatsink nor the 25mm fan mount. I replaced it with a 40mm fan mount and increase the area of flow for the fan. I also switched out the tips for the filament fans and spaced them further apart, this gives room for the wiring from the heater and thermistor.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
