Egg Piercer

This is a uni-tasker to help hard boil eggs. If you ever need hardboiled eggs (deviled eggs, easter, or whatever) it is always best if they survive the cooking without cracking.One of the easiest techniques to prevent cracking is to solve the pressure build up inside due to heat. This device will pierce a small, clean hole in the end of the egg and allow the expanding gas to escape from a little bubble in the fat end of the egg. The .3MF Print Profile (X1C) is set up to print the parts individually. This was to customize color and provide a higher resolution for the cup that is not needed for the other parts. The cup is the only part needing supports. I might decide to split that part and set it up to glue together, just because I hate supports. But this workd for now. A standard sewing machine needle provides the piercing. Very little pressure is required. Any material will probably work. I found PLA to be perfectly adequate. It is possible the spring may sag over time (just a suspici