Thingiverse
Music
Zum Modell
Egg Shaker
5
Downloads
9
Likes
0
Makes
Recommended: Print with flat surfaces facing down on the build plate.
Minimum Recommended Print Settings:
– Supports: Enabled
– Support Type: Tree supports
– On Build Plate Only: Enabled
– Threshold Angle: 20
Note for Threshold Angle: You can increase this number to add more supports. A setting of 20 may leave slight imperfections inside the egg, but it doesn’t seem to impact sound quality. A setting of 35 or higher will create too many supports, which are difficult to remove.
Minimum Recommended Print Settings:
– Supports: Enabled
– Support Type: Tree supports
– On Build Plate Only: Enabled
– Threshold Angle: 20
Note for Threshold Angle: You can increase this number to add more supports. A setting of 20 may leave slight imperfections inside the egg, but it doesn’t seem to impact sound quality. A setting of 35 or higher will create too many supports, which are difficult to remove.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
