Thingiverse
Egg Sunny Side Up
door sk8rad
10
Downloads
3
Likes
0
Makes
Nothing too complex here.
There is a 0.2 mm gap between the yolk and the white. That seemed to work well with my CR-10. At 0.1 it was too tight. So depending on the performance of your printer, you may want to scale the yolk up or down a percent or two to get that "perfect fit".
There is a 0.2 mm gap between the yolk and the white. That seemed to work well with my CR-10. At 0.1 it was too tight. So depending on the performance of your printer, you may want to scale the yolk up or down a percent or two to get that "perfect fit".
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!