Thingiverse
Ego fan bracket
von shclark101
0
Downloads
0
Likes
0
Makes
I made this because my ego fan bracket started braking almost immediately after I bought it.
I designed this with heat inserts ( ruthex M4 Threaded Inserts) from amazon and
iexcell 50 Pcs M4 x 30mm Thread Pitch 0.7 mm screws. however you will not need such long screws.
After completing it I needed realized I forgot the hose clamp on the right side, so I made the bracket and glued it on using E6000.
I designed this with heat inserts ( ruthex M4 Threaded Inserts) from amazon and
iexcell 50 Pcs M4 x 30mm Thread Pitch 0.7 mm screws. however you will not need such long screws.
After completing it I needed realized I forgot the hose clamp on the right side, so I made the bracket and glued it on using E6000.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
