EIBOS Polyphemus Hanger for AMS Riser V2

This shelf mounts to AMS Riser V2 to support the EIBOS Polyphemus Filament Dryer. I have a limited workspace, so I designed this to hang off my printer's side using my Riser. I have an X1C and believe this should work with P1S as well. It has a little kicker on the back of it to account for the offset the AMS Riser V2 creates over the printer, so it sits level and distributes the weight more evenly. I used a .6 hotend to make this out of PLA+. I purchased the dryer to run PA6-CF and have yet to dry it. The dryer and PLA crossed my mind, so it's a little overbuilt. I did open the bottom up to allow airflow to the dryer and minimize any heat buildup that could occur. It's two prints with minimal supports and uses dovetail fittings to slide together. FYI, the dovetail fittings do fit together rather sung. I didn't want any play with it suspended in the air. I used a C clamp with a little piece of wood to push the dovetails, and it worked like a charm. My first time posting