Thingiverse
Eiffel tower 75cm
von Mumzelbaby
92
Downloads
112
Likes
1
Makes
I've printed this model with the Ultimaker 2 (top parts) and the Ultimaker 3 (bottom parts).
The bottom parts needed support so what is better then water soluble support right?
Total print time : 270 hours
Total material used : PLA 157m / PVA 77m
Scaled up 600%
The bottom parts needed support so what is better then water soluble support right?
Total print time : 270 hours
Total material used : PLA 157m / PVA 77m
Scaled up 600%
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!