Eiffel Tower hueforge

This print was done at a 0.04mm layer height on a P1S with the door and top glass open without any problems. It was also printed on an H2S, where I similarly needed to open the door and top glass and lower the temperature by 5°C; the result was incredible. Boost Me Project: Torre effiel.hfpPrint at 100% infill with a layer height of 0.04mm with a base layer of 0.24mmThe Model is 285.71x500mm in sizeYou may print at higher layer heights below the Base Thickness of 0.44mmThe Max allowed Thickness is 2.84mm and the Actual Thickness is 1.92mm #000000 PLA BambuLab Tough Black Transmission Distance: 0.6 #c00d1e PLA BambuLab Basic Red Transmission Distance: 4 #ff9016 PLA BambuLab Basic Pumpkin Orange Transmission Distance: 5.5 #fce300 PLA BambuLab Basic Yellow Transmission Distance: 6 #e7ceb5 PLA BambuLab Basic Beige Transmission Distance: 8 #ffffff PLA BambuLab Matte Ivory White Transmission Distance: 3.5This print uses 6 unique filamentsSwap Instructions: Start with BambuLab Tough Black At