einscan pro tripod mount

I made this to mount my Einscan Pro scanner to my tripod. I wanted to make sure it would not come off no matter what angle it was put at. It maybe a little over board but, Hay I paid a lot for the scanner. The mount for the industrial pack works fine but, I am not always going to scan flat.

This fits right over the hand grip once bolted down with 2 1.5" long 1/4-20 bolts it is very secure. I also printed a set of knobs that the bolts go through and make it easier to close the two part together.

Holes in part 1 were tapped with a 1/4-20 tap holes in part 2 were drilled out with a 1/4"
drill bit as a clearance hole to bolt the two halves together. Center holes are for mounting on the tripod.