Thingiverse
Eken H9 Camera Case
by Sytar
30
Downloads
19
Likes
2
Makes
This is a remake of an Action Cam case that AlpineDrones made. I removed the mount point (may make another with one on there), and adjusted to print in PLA. I will try his in Ninjaflex when I get some in. This is a tight fit, everything appears to be lined up right.
Updated - Case with Mount bracket, also adjusted a few things on the original print; Front is a bit deeper, noticed that the lens was not completely recessed. Also adjusted the opening on the connections side to open the area where the mic is at. It still could use more, but it is better then it was.
Updated - Case with Mount bracket, also adjusted a few things on the original print; Front is a bit deeper, noticed that the lens was not completely recessed. Also adjusted the opening on the connections side to open the area where the mic is at. It still could use more, but it is better then it was.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
