Elecom EX-G Pro adjustable stand

Yet another Elecom EX-G Pro stand. This stand has the possibility to regulate the angle of inclination from 0 to around 46 degree.

Aside the printed parts the BOM includes:

+ 6 M3 nuts;
+ 1 M3x40mm screw;
+ 1 M3x50mm screw;
+ 4 M3x5mm screws.

## Printing tips

Use the printing orientation as shown in picture. Use standard setting except for the leveler: I suggest to print it with many walls to improve its robustness. Supports are not necessary.

The design of the top plate is remixed from https://www.thingiverse.com/thing:3983797 , whereas the design of knobs are remixed from https://www.thingiverse.com/thing:3778822 .

## Known bugs

+ The maximum inclination angle is limited to about 46 degree, for my taste must be extended by further 5 degrees, pretty much;
+ At the maximum inclination the trackball is somehow not well balanced: at high angles it si better to provide a "ballast" on the bottom of the stand.