Thingiverse
Music
Model downloaden
Electribe 2 Synth Stand
27
Downloads
27
Likes
0
Makes
Since I couldn't find a decent stand for my Electribe 2 Sampler, I did one by myself.
It is split into several pieces, so it can fit any printer with at least a 200x200mm print bed.
There different pieces for the backplate, as I included a blank version. Due to the LED strip at the lower front of the Electribe, the light shines through the back, if you cut something. It's neat and you should try it!
My first prototype was printed in blue and white PLA and still holds up well, so the stability should be given. Please be aware, that the supports from the logos at the sides are a bit of a pain to remove, if you make them too strong, since there is not too much space to wiggle them out.
It is split into several pieces, so it can fit any printer with at least a 200x200mm print bed.
There different pieces for the backplate, as I included a blank version. Due to the LED strip at the lower front of the Electribe, the light shines through the back, if you cut something. It's neat and you should try it!
My first prototype was printed in blue and white PLA and still holds up well, so the stability should be given. Please be aware, that the supports from the logos at the sides are a bit of a pain to remove, if you make them too strong, since there is not too much space to wiggle them out.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
