Electric desk remote holder

A rudimentary clip-on system that needs only two-sided tape. Print 1 plate and 2 bases (, just one or however many you need), tape the plate on the remote and two bases on opposite sides of the table and voila, all you need to do is unclip the remote from one side and clip it on the other.

The printing itself is simple. Use whatever filament you want, you can also scale it, however, I'd stray away from shrinking since some bits are already thin by design as is and decreasing the size might mess up the ramp that locks the plate. No supports are needed, flip the base 180 and you're good to go.

!!!! NOTE: the design's clip retention is based on the thickness of your tape, thicker tape means you can bend the release clip further upwards for easier detaching. If your tape is as thin as paper, it won't work as the clip doesn't have clearance to move upwards. I'm using 1mm thick tape.
!!!! NOTE 2: the dimensions of the plate that it taped to the remote are based on mine, which are X 45