Slicer Discord
Electric Eel – 3D printable model from GrabCAD GrabCAD
SOLIDWORKS 2011, STL

Electric Eel

696 Downloads
30 Likes
0 Makes
Go to Model
I call it Electric Eel. Reason is; I designed with a theme of a fish. Head lights, front Shell, top look everything gives a slight look of a fish. As far as it is an Electric car; electricity plus a fish the result is an electric eel. Two people can travel in this car. It has a luggage compartment located just behind the seats; which you can open 45 degrees of an angle. That little part consists of a solar panel which helps to recharge the battery during the day time. This car is a three wheeler, rear wheel drive. Rear tires are unusually widened to keep the balance. The doors can be open outwardly (Conventional door), then the Windscreen automatically opens 45 degrees of an angle as I have shown in images. It gives extra space for the driver to get off without any trouble. This has to be made out of very light materials in order to make it efficient. I hope this is more spacious, good looking and fast enough to move through the traffic. Thank you.
Category
SOLIDWORKS 2011, STL
Source
GrabCAD
Published
What you need to print this: Beginner Low confidence
Single piece
Supports 1/3
Assembly 0/3
Settings 1/3
Bed size 0/3
Post-process 0/3
Printer
FDM / FFF
File format
STL, STEP
Material
Software
Cura, PrusaSlicer, or similar
Same designer, more platforms

Niranjan also publishes on

4 additional models across 2 more platforms

Verified by matching model titles across platforms.
No ratings yet
No comments yet – be the first!

Similar Models

6 Suggestions
Feed Blog Slicer Cost Calculator Image Search Submit Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Add to Collection