Electric lock pick gun

Electric lock pick gun. This is a work in progress, the handle and motormount are separate, but I simply superglued them together once I had everything printed.

I have successfully used this on some simple locks, but I am no expert at using it. It likely has some major limitations compared to a professional electric lock pick gun, but still fun to build.

The cam gets super glued onto the motor shaft and due to it being off center, it creates the up and down ossilation motion of the pick.

The motor I used came from a remote control car that I had torn apart, but the size seemed pretty standard and could be found at most electronic stores. The button is from radioshack and the gun uses a 9v battery.

This does require a little soldering, post printing adjustements to make sure the pieces all run smoothly, and some superglue.

It's a little rough looking and is a work in progress, but I hope you enjoy.

Here's a video of it:
https://www.youtube.com/watch?v=08IF598p2gI