Hobby
Voir le modèle
Electric Longboard Conversion
425
Téléchargements
452
Likes
2
Makes
Alright, I was bored the other day and decided to make the longboard I just purchased into an electric board. (Too lazy to pump all the time) A couple hours later here's what I have. The designs are pretty crude but they work.
Parts:
Longboard
-Yoacher 41 inch drop deck board (The one i have)
Brushless motor
-Hobbyking 5055 400kv motor
80+ amp speed controller
-Turnigy 85A
Belt
-55 teeth 110XL synchronous belt
Pinion
1.5mm Pitch 10 Teeth 6mm Bore Motor Part Timing Belt Pulley Sprocket
2ch R/C car radio and reciever
-quanum 3ch
Your choice of battery (3s runs perfect I'd say around 10-15 mph 6s for dangerous speeds)
- 4000mah+ 20c+
That's pretty much it I printed the parts at 0.2mm layers at 100% infill on my prusia i3. Epoxy the wheel pulley onto the wheel and its good. Make sure its centered to avoid vibrations.
Bracket is friction fit so hammer it good in there.
Works well and cheap.
Oh yeah, you're going to need some extra spacers for th
Parts:
Longboard
-Yoacher 41 inch drop deck board (The one i have)
Brushless motor
-Hobbyking 5055 400kv motor
80+ amp speed controller
-Turnigy 85A
Belt
-55 teeth 110XL synchronous belt
Pinion
1.5mm Pitch 10 Teeth 6mm Bore Motor Part Timing Belt Pulley Sprocket
2ch R/C car radio and reciever
-quanum 3ch
Your choice of battery (3s runs perfect I'd say around 10-15 mph 6s for dangerous speeds)
- 4000mah+ 20c+
That's pretty much it I printed the parts at 0.2mm layers at 100% infill on my prusia i3. Epoxy the wheel pulley onto the wheel and its good. Make sure its centered to avoid vibrations.
Bracket is friction fit so hammer it good in there.
Works well and cheap.
Oh yeah, you're going to need some extra spacers for th
Vous avez imprimé ce modèle ? Connectez-vous et partagez votre make !
Connectez-vous pour laisser un commentaire
Se connecterPas encore de commentaires – soyez le premier !