Thingiverse
Electric Screwdriver Charging Stand
by Smndrd
6
Downloads
6
Likes
0
Makes
Great little desk holder and charger for my electric screwdriver.
Simply print upright in PLA or PETG
Add your bits around the screwdriver
Push the USB-C cable through the bottom until the connector goes through, add a bit of hot glue to hold in place (test connection before adding glue).
When charging you should see the light status illuminate through a dedicated opening.
Link the screwdriver: https://amzn.eu/d/jbwosFf
Be careful as it can easily be knocked over, if you print it with 100% infill it might help add some weight at the bottom.
Simply print upright in PLA or PETG
Add your bits around the screwdriver
Push the USB-C cable through the bottom until the connector goes through, add a bit of hot glue to hold in place (test connection before adding glue).
When charging you should see the light status illuminate through a dedicated opening.
Link the screwdriver: https://amzn.eu/d/jbwosFf
Be careful as it can easily be knocked over, if you print it with 100% infill it might help add some weight at the bottom.
Smndrd also publishes on
2 additional models across 1 more platforms
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
