Thingiverse
Electronic Bed Level - Ender 3 (Not tested)
von Kniksis
2
Downloads
4
Likes
0
Makes
This is a project based on the Electronic Bed Level Tool present on the CHEP channel.
As I didn't have easy access to a phenolite board, I decided to develop the entire piece in 3D. The concept will be to use transparent filament in the Central_Frame so that it glows in full when the mouse switch is pressed, making an interesting visual effect.
I also modified the Elec bed level 5_8 Offset.gcode file so that it works correctly on Ender 3 V1 without any difficulties. Download the file and use it to facilitate the leveling of the bed.
Check out the original project on YouTube:
Electronic Device for Easier Bed Leveling on any 3D Printer
https://youtu.be/715Xop79Sus
Electronic Bed Level Tool Kit:
https://bit.ly/3GguHKu
Assembled Electronic Bed Leveling Tool:
https://bit.ly/3rMV0Sv
More Info: https://bit.ly/3fO313T
*Obs.: The project is still in development and has not been fully tested, the first version was too wide so I decided to make this new one thinner.
As I didn't have easy access to a phenolite board, I decided to develop the entire piece in 3D. The concept will be to use transparent filament in the Central_Frame so that it glows in full when the mouse switch is pressed, making an interesting visual effect.
I also modified the Elec bed level 5_8 Offset.gcode file so that it works correctly on Ender 3 V1 without any difficulties. Download the file and use it to facilitate the leveling of the bed.
Check out the original project on YouTube:
Electronic Device for Easier Bed Leveling on any 3D Printer
https://youtu.be/715Xop79Sus
Electronic Bed Level Tool Kit:
https://bit.ly/3GguHKu
Assembled Electronic Bed Leveling Tool:
https://bit.ly/3rMV0Sv
More Info: https://bit.ly/3fO313T
*Obs.: The project is still in development and has not been fully tested, the first version was too wide so I decided to make this new one thinner.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!