Electronic case V1.1 - Ender 3

The case allows easy access to the board and has space for cable management in the space behind the board. Ready for SKR MINI E3 or similar board and Raspberry Pi ¾ or two StepDowns. Optimized for 0.4 nozzle and for supportless printing. Two positions for StepDowns have only one mounting hole each. Additional holes must be made according to the size of the component in the prepared posts. It is possible to install fans of sizes 50/60/80/120 with a thickness of up to 25 mm from the inside of the door. Mounting holes are provided for fans. For connecting the board and raspberry a bent usb cable is needed. In the back space there are preparatory grooves for Velcro which can be used for tying cables. Necessary fasteners 4 pcs DIN912 M5x16 screws for completing the two basic parts of the case together. 4-8 pcs DIN912 M5x16 screws for mounting on the printer profile. 4-8 pcs M5 nuts for T-profile on the printer profile. 3 pcs DIN912 M3x20 screws for hinges. 4 pcs DIN912 M3x20 screws for cable glands. 5 or more pcs DIN912 M3x6 screws for motherboard and other electronic parts. P.S. the photos do not correspond 1:1 to the models. After printing, I still fine-tuned the models, but not so much that I needed to print them again :).