Electronic Surface/Height Gauge

An add-on to your electronic caliper (fits most standard calipers). 2 version of calipers width
- up to 16mm width
- up to 17mm width

The gauge can be used to Router and Table Saw.

This is of course NOT a high precision solution, but it is quite flat and does its job within a 0.05mm error range.

###Assembly and Use

The hole is 3.5 mm diameter, so you can screw in a M4 bolt/screw without the need to cut a thread.
- Insert the caliper and fix it with a screw.
- If necessary, install a heel on the caliper probe.
- Place the gauge on a smooth, flat surface.
- Lower the caliper probe until it touches the base surface.
- Zero the caliper. Now when you lift the probe, the height will be displayed (as a negative value)

See also:
[Mechanical Surface/Height Gauge](https://www.thingiverse.com/thing:6826719)
[Surface Gauge](https://www.thingiverse.com/thing:6823421)