Electronics housing Anet A6

1 .Englisch (translate)

This is a small electronics housing for the Anet A6 printer. It was created to hide all cables and mount MOSFET transistors. The housing should be equipped with a 40mm fan for cooling the electronics. Behind the MOSFETs, there is a system that allows the printer to connect a 12v car battery, so you do not have to worry about the lack of electricity and print interruption. I do not recommend this housing for beginners, because some practical skills and knowledge of the basics of electronics are required. A lot of cables had to be shortened and well arranged to make everything fit. In addition, if someone wants, I can set up the Anet logo backlight, just like in my case.

My housing is printed entirely from PLA.
Average printing time and amount of plastic used:
- casing about 20 hours and about 100 g of plastic
- closing of the casing about 9-10 hours 60-70 g of plastic (when filled with 30-50%)
- lighting element 1 hour 5 g of plastic

2. Polish (origi